Iron Horse Diesel Repair

Concept design by Medeiros Web Design. Iron Horse Diesel Repair is a fictional business.

Bays 1 and 2

Engine and aftertreatment.

Most of what puts a late-model truck on the shoulder is in these two systems. Here is how we find the fault, what the common repairs cost and how long each takes.

Diagnosis first

A fault code tells you which system complained. It does not tell you which part failed. We test before we replace.

  • One hour, $135. That covers the scan, a road test if it is safe and a look at the live data.
  • Dealer-level software for Cummins, Detroit and PACCAR, so we can run the same tests a dealer runs.
  • A written estimate with the part, the labor hours and the reason.
  • Photos of anything we want you to see, sent to your phone.
  • If you have us do the repair, the diagnosis hour comes off the bill.
Hands holding meter probes against the pins of an engine wiring connector

Engine repairs

Usual ranges, parts and labor. Sample prices for this concept site.
RepairUsual timeUsual cost
One injector3 to 4 hours$850 to $1,300
Set of six injectors1 day$4,200 to $6,000
Turbo5 to 7 hours$2,800 to $4,500
EGR cooler6 to 9 hours$2,400 to $3,800
Water pump3 to 5 hours$900 to $1,500
Head gasket2 to 3 days$5,500 to $8,000
In-frame overhaul6 to 8 days$16,000 to $22,000

Every engine repair carries a 12 month, 100,000 mile warranty on our labor, on top of the part maker's own.

Aftertreatment, in plain words

Four parts clean the exhaust. When one stops working, the truck cuts its own power.

Aftertreatment repairs

Sample prices for this concept site
JobWhat it isTimeCost
Forced regenWe make the filter burn itself clean while the truck is parked1 hour$185
DPF cleaningThe filter comes off and is baked and blown out in our own machineSame day$450
DOC and DPF cleaningBoth cans, cleaned togetherSame day$650
DEF doserCleaned or replaced1 to 2 hours$380 to $700
DEF pump or headerReplaced2 to 3 hours$1,100 to $1,900
NOx sensorReplaced, after testing1 hour$520 to $680

We repair emissions systems. We do not delete them, and we will not tune around them.

Mechanic in coveralls leaning over a diesel engine with its valve cover off

An in-frame overhaul

New life for an engine with a sound block, done without pulling it from the truck.

  • New liners, pistons, rings, rod and main bearings, and a full gasket set.
  • The head goes to a machine shop to be checked, cut and fitted with new valves.
  • The oil cooler, the water pump and the oil pump are replaced while it is apart.
  • A dyno run before it leaves, with the printout in your folder.
  • Two years, unlimited miles, on parts and labor.

Service that prevents the big bills

Sample prices for this concept site
ServiceHow oftenWhat is doneCost
A serviceEvery 15,000 milesOil and filters, grease, a look underneath and a fluid check$389
B serviceEvery 30,000 milesThe A service, fuel filters, an air filter check and a brake measure$549
C serviceOnce a yearThe B service, coolant test, valve set check and a full DOT inspection$1,150

Tell us these and we find it faster

Asked about engine work

Can you clear a derate so I can finish the run?

Sometimes, once we know the cause. If it is safe to run, we clear it and tell you how far you have. If it is not, we say so.

How often should a DPF be cleaned?

About every 200,000 miles on a highway truck, and half that on one that idles or runs local.

Do you rebuild injectors?

No. We fit new or factory-rebuilt ones with a warranty. A cheap injector is the costliest part on a truck.

Can I supply my own parts?

Yes, at the same labor rate. Our warranty then covers the labor only.

Lamp on? Call before it shuts down.

Tell us the codes if you can read them. We will say whether to drive it in or stay put.