Refinishing and repairs.

Before you buy a new floor, look at the old one. Oak that has spent forty years under carpet is often the best floor in the house.

What it costs

Sample prices for this concept site
JobWhat it isPrice
Sand and refinishDown to bare wood, stain and three coats of finish$4 to $5 a square foot
Screen and recoatA light scuff and one fresh coat, for floors that are dull but not worn through$1.75 a square foot
Board repairsDamaged boards cut out and new ones laced in$18 a board, before refinishing
StairsTreads sanded and finished$55 a step
Pull carpet, pad and staplesSo we can see what is there75 cents a square foot

Is there wood under your carpet?

Five ways to find out without pulling it up.

A refinishing week

  1. Day 1: sandThree passes with finer paper each time. Our machines are sealed to a vacuum, so there is very little dust.
  2. Day 2: stainThree sample patches on your own floor first. You choose, then the whole floor is stained.
  3. Days 3 and 4: finishThree coats, with a light sand between. Each needs a few hours to dry.
  4. Day 5: walk on itIn socks. Furniture back after three days, and rugs after two weeks.

Stain and finish

Natural
No stain, only finish. White oak goes honey. Red oak goes a little pink.
Light and gray tones
Popular, and hard to do evenly on red oak. We test first.
Mid browns
The safest choice. Hides dust, dog hair and the odd scratch.
Very dark
Striking for a month. Then it shows every footprint and crumb.
Water-based finish
Clear, low odor, dry in hours. What we use on nine floors in ten.
Oil-based finish
Ambers with age and smells for days. For people who want the old look.

Can it be saved?

What we find, and what we do
What we findCan it be refinished?
Scratches, dull paths and old finishYes. That is what sanding is for
Gray boards where the finish wore offYes, if the wood is not soft
Pet stains gone blackSanding will not lift them. Those boards are replaced, or the floor is stained dark
Cupped boards from an old leakUsually, once the wood has dried out
Gaps between boardsSmall ones are left. They close in summer. Wide ones get slivers of wood
Nail heads showing along the groovesNo. It has been sanded as many times as it can be
Thin engineered woodSometimes, once. We measure the top layer first

Other repairs

Living through a refinish

Asked about refinishing

Refinish or replace?

If the wood is sound, refinish. It costs about half of new hardwood and the result is the same.

How dusty is it?

Far less than it was. The sanders feed a vacuum outside. You will wipe a little from the windowsills.

Can you change the color?

Completely. Sanding takes it back to bare wood, and any stain can go on.

How long before it needs doing again?

Fifteen to twenty years. A screen and recoat every five or so puts that off almost for good.

Let us look under the carpet.

A free visit, with a moisture meter and a flashlight. We lift one corner and tell you what you have.